Hi Bobbi Jo

Question 1:I have a simple valance with no header to make with inverted pleats with a scallop at the bottom of the center one and then a half scallop on each side. When I put in the dimensions the program gives a valance with a header. I am adding 12" 2x for the pleats to the width measurement. That sounds right? Right? too much? Should I decrease to 4" pleats?Then I will hand draft the scallop with a compass or something. For the scallop I will divide the width in threes. Put 2/3 in the middle and split the other 1/3 for either side of the center scallop. Does that sound right? I have a small picture I could send if it would help.

Problem 1: Again I cannot see the all the pages to click on when in print mode again. If you remember that happened once before. I think Bob put a scroll bar there but I seem to have lost it. Can't figure out how that happened. Haven't had any puter problems since then.

Well, I think that's it for now. Thanks for your help.