Its been a while since i did this, and my printer seems a bit off, the bottom pages don't allow me, enough room to put together and tape.target marks line up at 3" apart.My questions is this.
Do we got into our browser 1st, e.g IE setup there,then open DS and check setup in there?In my case I am using centermeters,so I know what settings I need for DS.Sorry but as I said, its been ages since i had to set my printer pagesetup,I had a glitch in my PC, and something changed my settings, when I noticed this I was printing a blouse off in MPD.

Freda, MPD and Dress Shop ARE different programs and each has its own page set up.

Make sure you set the MPD file>page settings to match your printer settings .

DS may be printing just fine..check it!
and do the page set up in MPD.

Kaaren

Kaaren its just my dS, I need to set up printer margins,but Ive forgotten the what proceedure we must do first, enter Internet Explore to set up printer there, then go to DS and check its set up properly for DS to print.Or do I forget going into I.E altogether?and just set up in DS only.TIA

go to printer and set there margings top and bottom to 0.50 and left right at 0.25, page size 8.5 by 11 adjust accordingly for metric

then DS see the margins match each other
Kaaren

Thank you Kaaren I figured it out, after asking this on the board.Have you ever been in a store, and couldn't find and item, then asking a saleslady to point in the right direction,to which you learn you were very close to the area of the item GGGG.It never fails eh.