After updating to 6.13 from 6.09 the armhole changed om my sheath pattern. I compared the 1/4" patterns. When looking at a new blouse pattern, it drafts with the same change. The scoop shape has made the high bust more narrow. I think that is the measurement that has affected it. Is this the measurement that I should try to change to get my oringinal arms hole? Thanks Susan Dickson. I have Pro and lots of tools.

That is VERY difficult to answer based on the information given. However; I would check your across back measurement first if the back is the most effected, and the high bust front if it is the front.

Here are the control points for the arm hole shape.
Above the notch front: across chest
back: across back
below the notch
front: high bust
back: bust back.

Kaaren

Actually, I'm thrilled with the changes in the armhole in 6.13 (just thought you guys should hear that). I had an incredible amount of fluff in the pattern there before...enough for an extra set of boobs.

THe changes tightened up the sloper to the point where it is skin tight there..not a wrinkle or fold anywhere. I didn't change measurements either.

I'm going to try a blouse. I'll let you know if the fluff stays gone in a real garment.

Fyfee