Hello, Kaaren,
I was wondering--it is possible to change the shape of the sleeve cap, when using MPDStandard or Pro? Having looked at some storebought patterns, I noticed that the front part of the sleeve went in a bit more than the MPD sleeve. Could I do something similar with MPD? The reason I ask is that, once again, I'm puzzling over the question--how to fit my slightly forward shoulders. Not sure if I'm on the right track, but any advice would be appreciated. Thanks in advance,
Susan

Sorry, right now I'm transfering files and programs to a new computer- so am unable to give a detailed response.

Your numbers will adjust the sleeve by adjusting the armhole.

For a greater "indent" in the front of the sleeve you need a smaller across chest measurement than across shoulder measurement in front.

To tilt the shoulder point forward you need a slightly longer back slope and possibly shorter front slope to set the shoulder poiint where you want it.

This is a very delicate balancing act and very accurate measurements are required.

You do NOT want a commercial pattern- dont attempt to clone one. Instead work towards a pattern that fits you.

Kaaren

Hello, Kaaren,
Thanks for the prompt reply. Yes, I thought that might be the way to go about it--to adjust the across chest measurement. However, last time I tried that, I didn't see a big change in the sleeve cap. I'm not sure why, so I'll go back and have another look at my MPD pattern later, when I have time. As to the commercial pattern, I'm not really trying to clone it, just to understand how it's done. I'm new to patternmaking, so I study anything I have available.
thanks again,
Susan

Hello, Kaaren,
I'm still very interested in this question of how to fit sleeves. I know you're busy at the moment, but, when you have time, I would love to hear more on this subject. I'm still having a bit of trouble with fitting forward shoulders, although everything else is going well.
Looking forward to hearing from you,
Susan