Using the men's wear packet, the collar width, placket width, facings, casings, and lapel extension do not adjust to the smaller size, I am trying to make the denim jacket for a Unidoll Jace.and the V inserts in the front look like a squared off figure 8.
shoulder front: 4 5/16
shoulder back 4 5/16
bust depth 3 1.4
bust 11 1/4
waist 8 11/16
abdomen 10 1/4
hip 10 7/8
shoulder drop 9/16
shoulder length 1 3/16
shoulder to waist 8 1/4
bicep 4
front armhole depth 2
back armhole depth 2 1/8

since the doll is roughly 1/3 human size, I've been manually adjusting by 1/3 the measurement, but it's steps I had hoped would be automatic. I had the same problem with Dollshop 5 but was hoping it had been resolved by version 8. Any suggestions or work arounds?

Would have used the problem report, but it gives me an error message